The Rencool DCSS kit is designed for multipurpose use. The system is made into 3 primary pieces to maximize the kits ability for easy installations when size may be a problem.
The system has a cooling capability of up to 4.2Kw and is available in both 12 & 24 volt versions.
Perfect applications may be camper trailers, dog floats, motor-home bedrooms, small machine cabs, truck sleeper cabins, Motorsport vehicles.
With only 18cc displacement capacity we can achieve higher rpm to obtain optimal cooling capacity with conservative power consumption.
2000 to 6000 rpm available depending on the application, Vent outlet temperatures regulate between +6 to + 10 degrees C @ +40 Deg Ambient
Ideally the controller should not be located within the engine bay due to excessive heats, the compressor is able to withstand 100’C but 70’C should considered due to external factors and residual heat.
If mounting within the engine bay heat shielding is required including the suctions lines. Careful considering should be taken prior to mounting in this location as the units life expectancy may shorten.
The Compressor must be mounted upright with the controller towards the top, Operating the compressor mounting on it's side or upside down may cause a critical failure to the unit.
The compressors rely on the cold flood back from the refrigerant to cool down the controller to keep it in check. Special Builds can be requested or controllers can be purchased to complete your own tests.
A minimum of 2B&S copper insulated cabling MUST BE used. Failing to use the recommended cabling will result in high current consumption, high resistance and over all poor performance from the entire DC voltage HVAC system. Length of cabling MUST BE calculated so resistance is kept to a minimum.
Your alternator must be above 100 amps on @12 volt and 24 volt and able to cope with your calculated other power consumption on the truck, machine, Van or any type of vehicle mobile or stationary etc used while in use must be sufficient to do all is required to run the truck, machine, Van or any type of vehicle mobile or
We recommend always best to consult Auto‐Electrician for these calculations. Original power cables, electrical system installed on the truck, machine, Van or any type of vehicle mobile or stationary etc must also be sufficient to handle the extra load from the Rencool compressor and/or complete system.